Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (12)
2026 · Paper 1 · Q10(v) · 18 marks · p.12
Calculate the slope of the graph and use it to calculate A.
2026 · Paper 1 · Q10(iv) · p.12
Draw a suitable graph on graph paper to show the relationship between the C and d.
2026 · Paper 1 · Q5(vi) · 19 marks · p.6
Calculate the resistivity of the wire at 25 °C.
2026 · Paper 1 · Q5(v) · p.6
State one experimental precaution that should be taken when determining the length of the wire.
2026 · Paper 1 · Q5(iv) · p.6
Describe how the student measured the diameter of the wire.
2026 · Paper 1 · Q5(iii) · 21 marks · p.6
Use your graph to determine the resistance of the wire when its temperature is 25 °C.
2015 · Paper 1 · Q1 · 12 marks · p.2
In an experiment to verify Boyle's law, a student measured the volume V of a fixed mass of gas at different values of the pressure p. The temperature of the gas was the same for each measurement. The following data were recorded. [Table: V (cm³) values are 80, 120, 160, 200, 240, 280. p (kPa) values are 324, 214, 165, 135, 112, 100.] Describe, with the aid of a labelled diagram, how the student obtained the data.
2015 · Paper 1 · Q12(c) · p.11
A thermometer uses a thermometric property to measure temperature. The thermometric property of a thermocouple thermometer is emf. Explain the underlined terms. What is the SI unit of temperature? Give an advantage of using this unit in scientific measurements. Describe a laboratory experiment to demonstrate the principle of operation of a thermocouple. Give an advantage of using a thermocouple thermometer instead of a mercury-in-glass thermometer. [Image: A digital thermometer probe and display.]
2015 · Paper 1 · Q2 · 9 marks · p.3
In an experiment to measure the specific latent heat of vaporisation of water, cool water was placed in a polystyrene cup. Dry steam was then added to the water. The following data were recorded. [List of data: Mass of polystyrene cup = 1.2 g, Initial mass of polystyrene cup and water = 84.6 g, Initial temperature of water = 11 °C, Temperature of steam = 100 °C, Final temperature of water = 30 °C, Final mass of polystyrene cup and water = 87.2 g] Draw a labelled diagram of the apparatus used in the experiment.
2015 · Paper 1 · Q3 · 15 marks · p.3
In an experiment to measure the wavelength of monochromatic light, a beam of light was incident normally on a diffraction grating. The diffraction grating had 80 lines per mm. The angle between the first order image to the left and the first order image to the right was measured. This was repeated for higher order images. The following data were recorded. [Table: n values are 1, 2, 3, 4. φ (degrees) values are 4.60, 9.18, 13.81, 18.44.] Draw a labelled diagram of the apparatus used in the experiment. How were the first order images identified? How was a beam of light produced?
2015 · Paper 1 · Q4 · 20 marks · p.4
In an experiment to measure the variation of the resistance R of a metallic conductor with its temperature θ, a student recorded the following data. [Table: θ(°C) values are 15, 20, 30, 40, 50, 60, 80, 100. R (Ω) values are 6.0, 6.2, 6.5, 6.8, 7.2, 7.5, 8.2, 8.8.] Using the recorded data, plot a graph to show the variation of the resistance of the metallic conductor with its temperature. Use your graph to estimate (i) the rate of change of resistance with respect to temperature for the metallic conductor (ii) the resistance of the metallic conductor when it is immersed in melting ice.
2015 · Paper 1 · Q9 · 24 marks · p.7
Musical instruments produce stationary (standing) waves. Resonance also occurs in many instruments. What are stationary waves? How are they produced? What is resonance? Describe a laboratory experiment to demonstrate resonance.