Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (3)
2025 · Paper 1 · Q6(a) · p.7
Identify any three of the centre lathe parts shown at A, B, C and D. [Image: Four parts of a centre lathe labelled A, B, C, and D.]
Marking scheme
A - Foot operated safety stop switch, B - Tailstock, C - Toolholder, D - Chuck safety guard. (Award 3 @ 5 Marks)
2024 · Paper 1 · Q1(h) · p.2
Name the type of chuck shown and give one suitable use for it. [Image: A three-jaw chuck used for holding cylindrical objects in a lathe.]
Marking scheme
Name: Award 3 Marks Use: Award 3 Marks Total (6) Marks
2018 · Paper 1 · Q1(i) · 35 marks · p.2
Answer any three of the following: Describe the main operating features of any one of the following: Four-jaw independent chuck [Image: A four-jaw independent chuck.] Strip heater [Image: A strip heater.] Knurling tool. [Image: A knurling tool.]
Marking scheme
Four jaw independent chuck: The jaws in this chuck can be moved independently of one another, each being controlled by its own screw. They are also reversible and therefore only one set is required. The four jaw independent chuck is used for eccentric turning and for gripping square, round, rectangular and irregular shapes. The work can be centered more accurately in this chuck than in the self-centering one, but it takes longer. The concentric circles on the face of the chuck serve as a guide when positioning the work. (12 marks) Strip heater: A strip heater is used to form straight or small curvature bends in thermoplastic sheet material. An electric element or hot wire is enclosed in a channel which has an opening at the top. Thermoplastic sheet is placed across supports above the opening. By adjusting the height of the supports the width of strip to be heated can be altered. The supports are set to a low height for tight bends. If a more gradual bend is required the heated area is widened by setting the supports higher. Different thicknesses of sheet may be formed by thermostatically controlling the heating temperature. (11 or 12 marks) Knurling tool: A knurling tool is used on a centre lathe to apply a grip to the surface of a piece i.e. scriber / centre punch. The knurling tool is fitted to the tool post and set at 90° to work. The knurling tool has two opposing rollers which are pressed into the piece and when moved parallel to the axis of the work will produce a diamond pattern on the surface of the material. (11 or 12 marks)