Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (2)
2021 · Paper 1 · Q1(m) · p.2
Name component B shown and state its function. [Image: A drill chuck labelled 'component B'.]
2021 · Paper 1 · Q1(i) · p.2
Describe the main operating features of any one of the following: [Image: An air compressor.] [Image: A strip heater.] [Image: A three-jaw chuck.]
Marking scheme
Any one: Air compressor: The compressor show has an electric motor, a compressor unit, and a storage tank. The electric motor drives the compressor unit which sucks air into a cylinder through an inlet valve. The air is then squashed (compressed) by a piston and forced into the storage tank. As the compressor continues to run, pressure builds up inside the storage tank. When it reaches a set level the electrical motor cuts off, stopping the compressor. The storage tank now stores the compressed air for use. When the pressure drops inside the storage tank, the electric motor starts again to bring up the level of pressure inside the storage tank. [Diagram: Air compressor with labels 'Electric motor', 'Compressor unit', 'Storage tank'.] [Award 7 (6) Marks] Strip heater: A strip heater is used to form straight or small curvature bends in thermoplastic sheet material. An electric element or hot wire is enclosed in a channel which has an opening at the top. Thermoplastic sheet is placed across supports above the opening. By adjusting the height of the supports the width of strip to be heated can be altered. The supports are set to a low height for tight bends. If a more gradual bend is required, the heated area is widened by setting the supports higher. Different thicknesses of sheet may be formed by controlling the heating temperature. [Diagram: Strip heater with labels 'Heated strip', 'Support', 'Hot wire'.]