Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (12)
2017 · Paper 1 · Q7(b)(iv) · p.8
The type of fit which will result from the assembly of the smallest shaft and the largest hole. [Visual aid: Diagram: a hole and shaft assembly with dimensions. Shaft diameter is 40.0±0.05 mm. Hole diameter is 39.0±0.05 mm.]
2017 · Paper 1 · Q7(b)(iii) · p.8
Largest diameter of the hole; [Visual aid: Diagram: a hole and shaft assembly with dimensions. Shaft diameter is 40.0±0.05 mm. Hole diameter is 39.0±0.05 mm.]
2017 · Paper 1 · Q7(b)(ii) · p.8
Smallest diameter of the shaft; [Visual aid: Diagram: a hole and shaft assembly with dimensions. Shaft diameter is 40.0±0.05 mm. Hole diameter is 39.0±0.05 mm.]
2017 · Paper 1 · Q7(b)(i) · p.8
State the: Nominal diameter of the shaft; [Visual aid: Diagram: a hole and shaft assembly with dimensions. Shaft diameter is 40.0±0.05 mm. Hole diameter is 39.0±0.05 mm.]
Marking scheme
Interference fit: Interference fit results when the smallest shaft is bigger than the largest hole. Force is needed to assemble the parts together. Tolerance: Tolerance is the difference between the upper and lower limits of a component to manufactured. 15±0.07mm Tolerance = 0.14mm [Description Award 2 @ 5 Marks Total (10)]
2016 · Paper 1 · Q7(a) · 45 marks · p.7
Explain any two of the following terms in relation to limits and fits: (i) Clearance fit (ii) Upper limit (iii) Transition fit.
2015 · Paper 1 · Q7(b)(iv) · p.6
A hole and shaft assembly are manufactured to the dimensions shown. [Diagram: A hole with diameter 20 +/- 0.08 and a shaft with diameter 20 +/- 0.06.] State the: The type of fit which will result from the assembly of the largest hole and the smallest shaft.
2015 · Paper 1 · Q7(b)(iii) · p.6
A hole and shaft assembly are manufactured to the dimensions shown. [Diagram: A hole with diameter 20 +/- 0.08 and a shaft with diameter 20 +/- 0.06.] State the: Smallest diameter of the shaft;
2015 · Paper 1 · Q7(b)(ii) · p.6
A hole and shaft assembly are manufactured to the dimensions shown. [Diagram: A hole with diameter 20 +/- 0.08 and a shaft with diameter 20 +/- 0.06.] State the: Largest diameter of the hole;
2015 · Paper 1 · Q7(b)(i) · p.6
A hole and shaft assembly are manufactured to the dimensions shown. [Diagram: A hole with diameter 20 +/- 0.08 and a shaft with diameter 20 +/- 0.06.] State the: Nominal diameter of the hole;
2015 · Paper 1 · Q7(a)(iii) · p.6
Describe any two of the following terms in relation to limits and fits: Allowance.
2015 · Paper 1 · Q7(a)(ii) · p.6
Describe any two of the following terms in relation to limits and fits: Interference fit,
2015 · Paper 1 · Q7(a)(i) · p.6
Describe any two of the following terms in relation to limits and fits: Lower limit,