Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (3)
2022 · Paper 1 · Q6(a) · p.7
Name any three of the labelled parts on the lathe below. [Diagram: A metalworking lathe with parts labelled A, B, C, and D.]
Marking scheme
Name any three: A: Emergency switch B: Chuck C: Tool post D: Tailstock Name Award 1 @ 7 Marks Award 2 @ 5 Marks Total (17) Marks
2017 · Paper 1 · Q6(a)(iii) · p.7
Give one reason why a lathe cutting tool must be positioned on centre before machining. [Visual aid: Image: a close-up of a metal cutting operation on a lathe.]
Marking scheme
If the cutting tool is on-centre it will cut to the middle with the minimum force. If it is below centre, a small piece will remain uncut at the centre and climbing can be an issue. While if above centre, rubbing and a poor finish will result. [1 reason for each part Award 3 @ 5 Marks Total (15) Marks]
2017 · Paper 1 · Q6(a)(ii) · p.7
Give one reason for changing the speed of the chuck when machining on a centre lathe. [Visual aid: Image: a close-up of a metal cutting operation on a lathe.]
Marking scheme
Reasons for changing the speed of the chuck include, the diameter of the workpiece, diameter of drill piece and machining operation. [1 reason for each part Award 3 @ 5 Marks Total (15) Marks]