Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (1)
2014 · Paper 1 · Q7 · 45 marks · p.6
Question 7. (a) Using sketches, describe the difference between a clearance fit and an interference fit in a shaft and hole assembly. [Sketches: illustrating clearance fit and interference fit.] (b) A hole is produced in a brass plate to the dimensions shown. State the: (i) Nominal diameter of the hole; (ii) Smallest diameter of the hole; (iii) Largest diameter of the hole; (iv) Tolerance of the hole. [Diagram: a hole with dimensions 43 ±0.05 mm.] (c) Name any three of the instruments shown and give one application of each instrument named. [Images: (i) A set of feeler gauges. (ii) A surface plate. (iii) A micrometer. (iv) A digital caliper.] OR (c) Name each of the electronic components represented by the circuit symbols shown and outline the function of each component named. [Circuit symbols: (i) A diode. (ii) A single-pole single-throw (SPST) switch. (iii) A battery or DC voltage source.]