Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (6)
2022 · Paper 1 · Q3(b)(ii) · p.5
With reference to metal B, describe with the aid of a diagram, the profile of the tensile test specimen when subjected to a load value of 158N/mm².
2022 · Paper 1 · Q3(b)(i) · p.5
Using the graph paper supplied, plot the stress-strain diagram for metal A and the stress-strain diagram for metal B on the same graph axes, as shown opposite. [Graph: axes labelled 'Stress (N/mm²)' and 'Strain (x1000)'. Two lines are shown, one labelled 'Metal A' and one labelled 'Metal B'.]
2019 · Paper 1 · Q2(b)(i) · p.5
Using the graph paper supplied, plot the stress-strain diagram for metal A and the stress-strain diagram for metal B using the same graph axes, as shown opposite. [Graph: blank axes for plotting stress-strain diagrams.]
Marking scheme
[Graph: Stress (N/mm²) vs Strain (x1000) on the same axes. Blue line (Metal B) shows a linear elastic region up to approx. 150 N/mm², then a yielding region up to approx. 175 N/mm² at a strain of 5x1000, followed by a plateau and slight decrease. Red line (Metal A) shows a linear elastic region up to approx. 300 N/mm², then a sharp increase in stress up to approx. 425 N/mm² at a strain of 2x1000, followed by fracture.] (10 marks)
2019 · Paper 1 · Q2(b) · p.5
The results shown below were obtained from tensile tests on two metals, metal A and metal B. [Table: Tensile test results for Metal A and Metal B showing Stress (N/mm²) and Strain (x 1000) at various points.]
2019 · Paper 1 · Q2(a)(ii) · p.5
Describe, with the aid of a diagram(s), a test for metal hardness. [Diagram(s): illustration(s) of a metal hardness test, e.g., Rockwell or Brinell.]
Marking scheme
Any suitable hardness test, Vickers test is shown. [Diagram: Vickers hardness test showing a square base pyramid indentor with a 136° angle, pressing into a test material, creating an indentation with diagonal 'd'.] The hardness value for a Vickers hardness test is converted from the length of the diagonal produced by the indenter. It is suitable for testing hard materials with a good degree of accuracy. (10 marks)
2016 · Paper 1 · Q2(b) · p.5
The results shown below were obtained from tensile tests on two non-ferrous metals, metal A and metal B. [Table: Tensile test results for Metal A and Metal B, showing Stress (N/mm²) and Strain (x1000) at various points]. Metal A: Stress (N/mm²) 45 90 135 200 275 308 335 345 340 Metal B: Stress (N/mm²) 16 28 40 53 68 75 79 78 75 Strain (×1000) 0.50 1.00 1.50 2.25 3.25 4.00 5.00 6.50 7.50 (i) Using the graph paper supplied, plot the stress-strain diagram for metal A and the stress-strain diagram for metal B using the same graph axes, as shown opposite. [Graph: Blank axes for plotting stress-strain diagrams]. (ii) Find the ultimate tensile strength value for metal A and the ultimate tensile strength value for metal B. (iii) Compare metal A and metal B under the following headings: • Ductility • Tensile strength.