Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (12)
2026 · Paper 1 · Q1(c)(ii) · p.2
State the colour change that would be observed at the endpoint in this titration.
2026 · Paper 1 · Q1(c)(i) · p.2
Identify a suitable indicator for use in this titration.
2017 · Paper 1 · Q1(c) · 15 marks · p.2
Describe fully the procedure used during the titrations to ensure the accuracy of the end point. What observation indicates that the correct end point has been reached?
Marking scheme
swirl flask while adding manganate(VII) (solution from burette) // rinse down inside walls (sides, inside) of flask (container, vessel) with deionised (distilled, pure) water at intervals // add manganate(VII) dropwise (slowly) as end point is approached // read burette at eye-level // keep burette vertical // read top of meniscus // carry out a rough titration // repeat to find two or more titres (readings) that agree to within 0.1 cm³ // use a white tile (surface, paper) to see colour changes in flask clearly [Allow 'beaker' for 'flask'.] faint (pale) pink colour remains ['Pink to colourless' not acceptable.] ANY FOUR: (4 × 3)
2016 · Paper 1 · Q1(e) · 5 marks · p.2
Starting with a primary standard solution made from anhydrous sodium carbonate, what two titrations are required to standardise a sodium hydroxide solution?
Marking scheme
WHAT: anhydrous sodium carbonate titrated with a strong acid hydrochloric acid (HCl), sulfuric acid (H2SO4), nitric acid (HNO3)} // acid titrated with sodium hydroxide (NaOH) solution (3+2) [Award (3) for correct titrations in reverse order.]
2016 · Paper 1 · Q1(d) · 9 marks · p.2
Find the concentration of ethanoic acid in the original vinegar (i) in terms of moles per litre, (ii) as a percentage (w/v).
Marking scheme
FIND: (i) 0.8 M (3) 0.00008 × 1000 × 10 = 0.8 moles/L (3) / 0.08 (Molarity***) × 10 = 0.8 moles/L (3) (ii) 4.8% (w/v) (6) 0.8 × 60* = 48 g/L (3) / 0.08 moles/100 cm³ (3) 48 / 10 = 4.8 g/100 cm³ = 4.8 % (w/v) (3) / 0.08 × 60* = 4.8 g/100 cm³ = 4.8% (w/v) (3) [*Addition must be shown for error to be treated as slip]
2016 · Paper 1 · Q1(c) · 12 marks · p.2
Calculate (i) the number of moles of sodium hydroxide in each 25.0 cm³ portion, (ii) the number of moles of ethanoic acid per cm³ of diluted vinegar.
Marking scheme
CALCULATE: 0.0015 (1.5 × 10-3) moles (6) M = 1.20 × 2 / 40* = 0.06** M (3) 1.20 / 20 = 0.06 g in 25 cm³ (3) 1.20 / 40* = 0.03 moles/500 cm³ (3) 0.03 / 25×0.06 / 1000 = 0.0015 moles/25 cm³ (3) 0.06 / 40* = 0.0015 moles/25 cm³ (3) = 0.0015 moles/25 cm³ (3) [*Addition must be shown for error to be treated as slip.] (ii) 0.00008 (8 × 10–5) moles per cm³ (6) 0.0015 moles CH3COOH (3) / 18.75 × M / 1 = 25 × 0.06 / 1 = 18.75 × M / 25 × Molarity** / 1 = 1 M = 0.08*** M (3) 0.0015 / 18.75 = 0.00008 (8 × 10–5) moles per cm³ (3) 0.08 / 1000 = 0.00008 (8 × 10–5) moles per cm³ (3)
2016 · Paper 1 · Q1(b) · 9 marks · p.2
Name a suitable indicator for this titration. What colour change is observed at the end point?
Marking scheme
NAME: phenolphthalein (3) WHAT: from pink (purple) (3) to colourless (3) [Colours reversed unacceptable.] [‘Clear' unacceptable for ‘colourless'.]
2016 · Paper 1 · Q1(a) · 15 marks · p.2
Describe in detail the procedures involved in measuring a 25.0 cm³ sample of the vinegar and diluting it using deionised water to exactly 250 cm³.
Marking scheme
MEASURE: use 25 cm³ pipette (burette) // previously rinsed with deionised (distilled, pure) water // and previously rinsed with vinegar (solution it will contain, sample) // pipette: read at eye-level / read bottom of meniscus / bottom of meniscus on the mark / allow drainage time / last drop to remain (not to be shaken out, blown out) / drain under gravity / touch (tip, tap) pipette against wall of flask burette: read at eye-level / jet (part below tap) full / vertical / read bottom of meniscus ANY THREE: (3 × 3) DILUTE: transfer to 250 cm³ volumetric flask // previously rinsed with deionised (distilled, pure) water // fill with deionised water until bottom of meniscus is on mark // stopper and invert flask a number of times / stopper and mix contents thoroughly ANY TWO: (2 × 3) [Award marks for reference to ‘bottom of meniscus' once only in (a).]
2015 · Paper 1 · Q1(c) · 9 marks · p.2
Name a suitable indicator for this titration. At what stage is the indicator added? State the colour change at the end point in the presence of the indicator.
2014 · Paper 1 · Q1(d) · 9 marks · p.2
Name a suitable indicator for this titration. State the colour change in the titration flask at the end point.
2014 · Paper 1 · Q1(c) · 6 marks · p.2
State one precaution that should have been taken as the end point of the titration was approached. Explain how this precaution would have contributed to the accuracy of the titration result.
2014 · Paper 1 · Q1(a) · 5 marks · p.2
Explain the underlined term. [Diagram: A titration setup showing a burette filled with liquid, a conical flask below it containing a different liquid, and a stand holding the burette.]