Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (2)
2015 · Paper 1 · Q1(c)(ii) · p.7
Describe a method of attaching the pegs to the base of the toast rack. Use sketches to illustrate your answer. Method: Sketches [Visual aid: Image: An alternative design for a toast rack with a wooden base and plastic pegs.]
2015 · Paper 1 · Q2(c) · 8 marks · p.9
The base unit opposite has been vacuum formed using high impact polystyrene (HIPs). Outline three steps in the process of vacuum forming and make a sketch of the mould/plug needed to make the base unit. Step 1: Step 2: Step 3: [Diagram: A vacuum-formed base unit and a mould.]
Marking scheme
The base unit opposite has been vacuum formed using high impact polystyrene (HIPs). Outline three steps in the process of vacuum forming and make a sketch of the mould/plug needed to make the base unit. Step 1: Pre-heat the vacuum former and place the mould/plug into the vacuum former. [2 marks] Step 2: Clamp the HIP and pull over the hood until the plastic is soft enough to form. [2 marks] Step 3: Push back the heater hood, switch on the pump and raise the mould/plug into the plastic. Allow to cool and vac-blow the plastic to release the mould. [2 marks] Sketch: [Sketch of the mould/plug for the vacuum forming process. The marking scheme indicates a scale for quality of sketch: No Sketch 0 marks, Quality of the sketch 1-2 mks.]