Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (2)
2018 · Part B · Q2(a) · 4 marks · p.4
The 555 timing circuit design shown is to be used in a novelty toothbrush holder. The circuit operates a motor, for a set time, to animate the novelty figure when the switch B, connected to pin 2, is pressed. [Circuit Diagram: A 555 timer IC circuit diagram with components R1, R2, R3, C1, C2, a switch B, and a motor M. Power supply is +9V and 0V. A 555 chip is shown with pin numbers. An image shows a novelty toothbrush holder with a figure on top.] (i) Two switches are available for use at B. One is labelled PTM and one is labelled PTB. Which one should be used in this situation? Explain the meaning of its label. (ii) Using a sketch, indicate how the pins 1 and 5 on the 555 chip are identified. (iii) Name the components which can be used to change the time delay in this circuit. (iv) The relay attached to pin 3 is labelled SPDT. Explain this label. Sketch the pin arrangements for a DPDT relay. (v) An additional component is normally connected across the coil of the relay to protect the chip. Name, and draw the symbol for this component. (vi) The resistors used in this circuit have a gold coloured fourth band. Explain the meaning of this band.
Marking scheme
USB: 2 mks Universal Serial Bus
2014 · Part B · Q2(a) · 25 marks · p.4
The diagram shows the component layout for a flashing LED circuit. (LED1 on, LED2 off, LED1 off, LED2 on) [Circuit diagram: A flashing LED circuit with two transistors (T1, T2), two LEDs (LED1, LED2), four resistors (R1, R2, R3, R4), and two capacitors (C1, C2). The circuit is powered by a +9V supply and connected to 0V. The LEDs are connected in series with resistors R1 and R4 respectively. The transistors are NPN type, configured in a common-emitter arrangement, with their bases connected to the junction of a resistor and a capacitor from the other transistor's collector. The LEDs are labelled LED1 and LED2. The transistors are labelled T1 and T2. The resistors are labelled R1, R2, R3, R4. The capacitors are labelled C1 and C2.] (i) LED1 has the following values: Vf = 2V and Imax = 0.02A. Calculate the required value of R1 in the circuit shown. (ii) The required value of resistor R2 is 47kΩ. Use the resistor colour codes shown below to determine the colour bands of this resistor. [Table: Resistor Colour Codes. Columns: Colour, Digit. Rows: Black (0), Brown (1), Red (2), Orange (3), Yellow (4), Green (5), Blue (6), Violet (7), Grey (8), White (9).] (iii) Identify the components shown at C1 and C2. What unit is used to measure the value of C1 and C2? What effect will increasing the value of these components have on the operation of the circuit? (iv) Copy the symbol for transistor T1 into your answerbook and indicate clearly the position of the base and the emitter.