Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (3)
2017 · Paper 1 · Q2(d) · 8 marks · p.9
The smallest rectangular piece of plastic needed to make the side panel is shown below. On this plastic mark out the shape of the side panel. Show the positions of the holes for the LED and switch. (Estimate the dimensions for the hole positions). [Image: A rectangular piece of plastic and a side panel with holes for LED and switch.]
2017 · Paper 1 · Q3(c)(i) · 14 marks · p.11
The flat-pattern of the part used to support the solar cells is shown. List three tools used in the marking-out of this part. Tool 1: Tool 2: Tool 3: [Graphic: A flat pattern for a part to support solar cells.] [Visual aid: flat pattern for solar cell support]
2014 · Paper 1 · Q1(d) · 8 marks · p.7
(i) The material for making the alternative base is shown. Draw in all the lines required for marking out the bends at the four corners. (ii) The marking out of the bend lines at all four corners must be exactly the same. Give a reason for this. Reason: [Diagram: A shaded area representing the material for the alternative base, with lines indicating where bends should occur at the corners. Dimensions R10, R20, R35 are shown.]