Study notes
No notes have been generated for this topic yet. Open the topic page online and click Generate notes first.
Past exam questions (8)
2019 · Paper 1 · Q1(d) · 12 marks · p.7
A switch and five LEDs must be connected to the Printed Circuit Board shown below. Sketch in the wire connections from each component to the PCB so that the switch activates all five LEDs. [Image: A Printed Circuit Board (PCB) labelled 'GAME PCB', a single-pole double-throw (SPDT) switch labelled '2A 250 VAC', and five Light Emitting Diodes (LEDs) with wires.]
2017 · Paper 1 · Q2(c) · 6 marks · p.9
A printed circuit board (PCB) is used to build the control circuit for the model helicopter. A resistor is included in the circuit to reduce the voltage across the LED. Sketch in the wire connections from each component to the PCB so that the switch activates both the motor and the LED. [Image: Components for a model helicopter circuit: a motor, an LED, a switch, a PCB, and a battery snap.]
2015 · Paper 1 · Q15(a) · 80 marks · p.4
Dynamo torches do not use: [Image: A hand-crank dynamo torch.]
2015 · Paper 1 · Q16(a) · 80 marks · p.5
LED stands for: [Image: Five LEDs in a row, showing different colours and clear casings.]
2015 · Paper 1 · Q18(a) · 80 marks · p.5
The resistance of an LDR varies with: [Image: A Light Dependent Resistor (LDR).]
2015 · Paper 1 · Q19(a) · 80 marks · p.5
The total resistance in this circuit is: [Circuit diagram: A series circuit with a 100 Ohm resistor and a 200 Ohm resistor connected to a power source.]
2015 · Paper 1 · Q2(d) · 8 marks · p.9
The components for the operation of the Steady Hand Game are shown. Draw in the connections between the components to complete the circuit for the game. (The LED has been omitted.) [Image: Components for the Steady Hand Game: battery holder, switch, buzzer, wire, and dinosaur shape with contact points.]
2015 · Paper 1 · Q2(a) · 80 marks · p.2
The symbol shown represents a: [Image: A USB symbol.]